Demon DL3600 Hard Cased LiPo 3600 mAh 7.4v High 25C Rating

For charging and care information, please see the pdf document.

• Full moulded hard case, which will take hard knocks and rough handling.
• The packs have built-in locators (part of the moulding) on the underside for use in saddle pack format chassis. These will not fly out of your car in a hurry!
• Rounded ends for use in stick format chassis.
• All the wires exit the battery pack on one side (NOT the centre) so strapping tape can be used effectively down the centre line of the pack.
• Heavy duty connector wire with Deans plug, for easy installation and safe charging.
• 3 pin balance plug to use with balance chargers and dischargers, if necessary
• 7.4 volt maintained throughout discharge, Maintain full speed from start to finish.
• Medium-High 3600mAh? capacity, (4500 mAh tested,? discharge to 7.0V. Average voltage 7.68V)
• Very High discharge - rated at True 25C for high punch and full brushless power without drop.
• Rated at 950 amps continuous.
• Very low internal resistance (4.1mOhm tested). High punch and power delivery.
• Very high efficiency (low internal resistance). No power lost as heat in the battery.
• BRCA Approved

LiPo cells do not require any discharge between runs.? Just keep topping them up between races.

This is a 2S1P (2 series, 1 parallel - 3.7 volts per cell , 7.4Volt total)? .Make sure you set your charger to correct settings. (Can be charged at 5 Amps with 8.40V cutoff)

You MUST use a LiPo Charger, and balance charging is recommended .

Weight:

255gm? Easily get your car to the weight limit. ( A NiMh battery will weigh 422gm)

Dimensions:

Height: 22.50mm(excluding locators on underside)

Width: 47mm (at widest point in the centre) Rounded shoulders.

Length: 137.5mm long. (Not oversized, so will fit)

We truly believe that our? LiPo Cells are superb value for money and of very high quality.

Chassis Notes (Confirmed Fitment)

• Hot Bodies Cyclone - perfect fit.
• XRay '008 - Perfect Fit
• Tamiya TRF416 - Perfect Fit
• Tamiya TA05 -Perfect fit
• Yokomo BD: Remove battery tray. File 2mm from upper brace. Shorten top deck screw. File corner of motor mount.

NOTE:

Do NOT get confused with more expensive packs thinking they are any better. The packs have then been made direct from our manufacturers with no fancy packaging but just what you need to race at a very high level.

Fig 1. Showing Underside with Locators built-In.

Fig 2. Showing side view of rounded end for stick usage.

ready platinum race spec TP32002S TP49002S 50004RS1801 reference carbon edition 3200 4500 4900 4800 3600

Lithium Polymer trackpower orion core-rc 4900