Demon Fan40M. Maglev Ultra airflow 40mm fan
Very high airflow 40mm square fan. 8cu.ft/min. (13.6m3/h)
Ultraslim at 10mm . Lightweight 13gm
MagLe Vapo bearing. (Magnetic levitation) See below.
Nominal operation voltage 5V,
Use direct to 7.4V battery for best results
Tough and long lasting.
Note: No plug on the wires.
Solder a Futaba receiver plug to the wires if plugging into the receiver.
Solder direct to speed control + and - or fit a 2 pin BEC plug/socket (18500010 and 185000020)
Fits the LRP Nosram heatsinks.
- Current Rating:215mA
- Flow Rate:8cu.ft/min (13.6m3/h)
- 7000rpm nominal (5V)
- Picture below shows fan fitted over motor, blowing down.
- Use a servo arm or similar to place motor, and fit a 2 pin plug for easy removal
- Fan can run from the Lipo voltage (7.4volt)
Sunon’s MagLev® Technology provides a fan design created to provide superior performance, low noise and long life. By using magnetic levitation force (MagLev), these fans feature zero friction with no contact between shaft and bearing. With excellent rotational stability, the MagLev fan eliminates vibration and typical wobble and shaking typically experienced in fan motors. MagLev also provides excellent high temperature endurance that results in long life. And, MagLev models also feature all-plastic manufacture of major items for optimal insulation resistance and electrostatic discharge (ESD) performance.
|Sunon offers quality answers to questions regarding the benefits of good bearing design in Sunon fans. Most models are provided with a choice of bearings, including standard ball bearing, sleeve, and Sunon’s proprietary Vapo-Bearing™ technology, one of industry’s most effective designs that virtually eliminate wobbling, reduce bearing wear, offer exceptionally quiet performance and increase fan life at a cost that is no more than is typical with ordinary fans. Both technologies are patented and include state-of-the-art advances in bearing surface materials and impeller stabilization.