SPEC.R SPR009-XR34 34T gear diff for XRay 009

34teeth pulley

Steel outdrives take 3.5mm blades

21.7mm between bearing faces (Uses standard 10mm hole shims if necessary for end float)

NOTE: Requires gear diff oil. Use 1000cst for rear diff

Only part fill the diff with oil or there will be too much drag.

Be careful to only sand moulding flash from the back of the large gears and housing face.

carefully tighten the screws while rotating gears to make sure they do not bind.

Grease the O ringsto prevent oil leaks from outputs

Lightly grease the white paper gasket with a heavy type of grease to help it seal.

Grease the output cups shafts before assembly